The Ajax 12V PSU replaces the 110/230V power supply unit in the Hub2, this allows for Ajax systems to be powered through a 12V power outlet, commonly found in caravans, external buildings, vehicles or anywhere else where you’d find a 12V power outlet.
This then gives the ability to keep yourself and your belongings protected when in a caravan, in an external building or a car. Installation is easy, just follow these simple steps:
-
Remove SmartBracket from the back of the device
-
Make sure the device is switched off using the power button (hold this down for 2 seconds)
-
Disconnect power and ethernet cables
-
Remove four screws of the back lid and take off.
-
Remove the screws which attached the boards to the device body
-
Remove both boards, keeping them together & not disconnecting them
-
Disconnect the power supply unit from the main board
-
Connect 12V PSU for Hub2 to the mainboard using the eight-pin connector.
-
Reassemble the boards and tighten the screws
-
Connect power
-
Switch on the 12V Power source
-
Switch the device back on by holding the button down for 2 seconds
-
Close and fix the SmartBracket to mounting panel